Welcome to Emissions Guide
Air Pump Emissions Ford 1972 460 Article
. For a permanent link to this article, or to bookmark it for further reading, click here.
Deciphering Vehicle Emissions Control Information
from:For most makes and models of cars, trucks and SUV's a vehicle emissions control information sticker can be found somewhere under the hood, usually close to the front and right side of the inside of the hood where it is clearly visible. The purpose of this decal is to provide the mechanic with the specific vehicle emissions control information that will be required when repairing or working on the engine.
There are several abbreviations used on the vehicle emissions control information sticker and they include:
• BPA – by pass air
• CONV – conventional system
• EGR – exhaust gas recirculation
• EGR BPT – exhaust gas recirculation back pressure transducer
• EVAP – evaporative emission
• EVAP CSP – evaporative emissions canister storage/purging
• IAC – idle air control
• IAC FIC – idle air control fast idle control
• PCV – positive crankcase ventilation
• TI – transistorized ignition
• WU-TWC – warm-up three way catalytic converter
• UB – underbody
• TWC – three way catalytic converter
• VCC – vacuum cut control solenoid
As a vehicle owner you won't need to know or remember these terms, however the vehicle emissions control information sticker and the schematic drawing that shows these different areas of the engine are essential for your repair professional.
The easiest way for a driver to know when the vehicle has noted a problem with in the vehicle emissions control system is that the malfunction light will come on in the dash. Depending on the model and type of vehicle that you drive the light will be different. Typically there is some type of "check engine" message that is associated with the particular in-dash system, but in addition the vehicle will also store a record of what was happening in the engine within the computer memory. When you take your vehicle to the repair shop their diagnostic computer interacts with your vehicle computer chip, allowing the computer to literally help diagnosis the malfunction in your vehicle. In order to properly set and repair the vehicle, the vehicle emissions control information that is specific to your vehicle and engine will be used.
The computer system will also clear itself after so many drive cycles are completed without the same fault or detection occurring. Depending on the make and model of your vehicle the number of drive cycles required to clear the system will vary, but it is typically around three. This means that if the reading was an abnormality that doesn't repeat, the car will actually reset it own computer chip and will cease to continue to alert the driver through the indicator light.
Air Pump Emissions Ford 1972 460 Specific links
Air Pump Emissions Ford 1972 460 News